Flowbench Manufacturing Australia Logo

HOME  |  PRODUCTS  |  FME200

FME200

Flow Bench FME200

The FME200P is the ideal Flowbench for Go-Karts, motorcycles & 6cyl. engines and it can: Record, Save, Graph, Report and Analise Flow Bench Data up to 200 cfm @ 28” wg on Windows operating systems. Making your flow testing: faster, easier, more accurate, and more professional. Streamline: recording, calculating, reporting and graphing of cylinder head Flow Bench data and see flow and power improvements from your porting and other engine modifications that can come from minor improvements in detail. For cylinder heads, these details not only include flow, but port velocity mapping with a pitot tube. You'll never use a calculator again. When sufficient data is available for a Valve Lift (or L/D point), CFM is calculated and graphed, with appropriate corrections made for test pressure variations (and temperature difference and bench calibration if needed). This machine will do 6cyl engines to over 300hp @ 28" wg and over 500hp @ 10" wg or V8's to over 400hp @28"wg.

FREE tuition via Teamviewer

  • New: PNEUMATIC Control. ALL slides have been eliminated making for fasted & easier operation
  • One Toggle switch to change direction readings instead of two manual switches
  • Able to Flow heads that flow more than the machines 28"wg capacity
  • The NEW FME machines can test at over 28in wg pressure
  • Potential HP readings on Pro software
  • Use your own Logo on printouts
  • Can do Port Velocity readings
  • Free Motor Controller
  • Quicker Flow readings
  • Overlay Head graphs
  • Less range changes
  • Easier to Calibrate
CAPACITY 200cfm @ 28in wg (@ 240v)
PRESSURE GAUGE Over 28in wg
FLOW MEASUREMENT Digital - Only 2 Ranges
THERMOMETER In & Out + Temp. compensation
THERMAL CUT-OUT 1
CONTROLS Motor, Pressure & Direction
POWER REQUIREMENTS 240 volts - 15 amps
DIMENSIONS 600w 640d 500h 50kg
MOTOR CONTROLLER Standard
HEAD ADAPTER PLATE Standard
HEAD ADAPTER INSERTS 2 of your choice - Standard

POWER REQUIREMENT figures are ONLY under MAXIMUM load. Most machines will never use maximum capacity. eg: the FME200 can be used for the majority of time on a 10amp line, even though it will draw about 14amps under full load. This machine can be used on the normal household power point.

Flow @ 28in wg
fma logo grey

Copyright © 2020 Flowbench Manufacturing Australia. All rights reserved.