Flowbench Manufacturing Australia Logo

HOME  |  PRODUCTS  |  FME400

FME400

Flow Bench fme400

The FME400P is the ideal Flowbench for engines up to V8's including Race boats and it can: Record, Save, Graph, Report and Analise Flow Bench Data up to 400 cfm @ 28” wg on Windows operating systems. Making your flow testing: faster, easier, more accurate, and more professional. Streamline: recording, calculating, reporting and graphing of cylinder head Flow Bench data and see flow and power improvements from your porting and other engine modifications that can come from minor improvements in detail. For cylinder heads, these details not only include flow, but port velocity mapping with a pitot tube. You'll never use a calculator again. When sufficient data is available for a Valve Lift (or L/D point), CFM is calculated and graphed, with appropriate corrections made for test pressure variations (and temperature difference and bench calibration if needed). This machine will flow V8 engines to over 800hp @ 28" wg and over 1300hp @ 10" wg. You can even do small engines such as Go-Karts & small motorcycles on these machines.

FREE tuition via TeamViewer

  • New: PNEUMATIC Control: ALL slides have been eliminated making for fasted & easier operation
  • One Toggle switch to change direction readings instead of two manual switches
  • Able to Flow heads that flow more than the machines 28"wg capacity
  • The NEW FME machines can test at over 28in wg pressure
  • Potential HP readings on Pro software
  • Use your own Logo on printouts
  • Can do Port Velocity readings
  • Free Motor Controller
  • Quicker Flow readings
  • Overlay Head graphs
  • Less range changes
  • Easier to Calibrate
CAPACITY 400cfm @ 28in wg (@ 240v)
PRESSURE GAUGE Over 28in wg
FLOW MEASUREMENT Digital - Only 2 Ranges
THERMOMETER In & Out + Temp. compensation
THERMAL CUT-OUT 1
CONTROLS Motor, Pressure & Direction
POWER REQUIREMENTS 240 volts - 28 amps
DIMENSIONS 720w 660d 550h 50kg
MOTOR CONTROLLER Standard
HEAD ADAPTER PLATE Standard
HEAD ADAPTER INSERTS 2 of your choice - Standard

POWER REQUIREMENT figures are ONLY under MAXIMUM load. Most machines will never use maximum capacity. eg: the FME400 can be used for the majority of time on a 10amp line, even though it will draw about 28amps under full load.

Flow @ 28in wg
fma logo grey

Copyright © 2020 Flowbench Manufacturing Australia. All rights reserved.