Flowbench Manufacturing Australia Logo

HOME  |  PRODUCTS  |  FME600

FME600

Flow Bench FME600

The FME600P is the ideal Flowbench for all engines, including Exhaust systems up to: Dragsters, Heavily modified road cars & Race boats & it can: Record, Save, Overlay Graphs, Compare Data, Graph, Report, Analise & Printout Flow Bench Data up to 600 cfm @ 28” wg on Windows operating systems. Making your flow testing: faster, easier, more accurate, and more professional. Streamline the recording, calculating, reporting and graphing of cylinder head Flow Bench data and see flow and power improvements from your porting and other engine modifications that can come from minor improvements in detail. For cylinder heads, these details not only include flow, but port velocity mapping with a pitot tube. You'll never use a calculator again. When sufficient data is available for a Valve Lift (or L/D point), CFM is calculated and graphed, with appropriate corrections made for test pressure variations (and temperature difference and bench calibration if needed). This machine will do V8's to over 1200hp @ 28" wg and over 2000hp @ 10" wg. Small motorcycles and Go-Karts are not a problem on this machine either.The FME600P can be wired in to single phase power or use an existing three phase power outlet.

FREE tuition via Teamviewer

  • New: PNEUMATIC Control. ALL slides have been eliminated making for fasted & easier operation
  • One Toggle switch to change direction readings instead of two manual switches
  • Able to Flow heads that flow more than the machines 28"wg capacity
  • The NEW FME machines can test at over 28in wg pressure
  • Potential HP readings on Pro software
  • Use your own Logo on printouts
  • Can do Port Velocity readings
  • Free Motor Controller
  • Quicker Flow readings
  • Overlay Head graphs
  • Less range changes
  • Easier to Calibrate
CAPACITY 600cfm @ 28in wg (@ 415v)
PRESSURE GAUGE Over 28in wg
FLOW MEASUREMENT Digital - Only 2 Ranges
THERMOMETER In & Out + Temp. compensation
THERMAL CUT-OUT 3
CONTROLS Motor, Pressure & Direction
POWER REQUIREMENTS 415 volts - 42 amps / 14 per phase
DIMENSIONS 800w 670d 550h 75kg
MOTOR CONTROLLER Standard
HEAD ADAPTER PLATE Standard
HEAD ADAPTER INSERTS 2 of your choice - Standard

POWER REQUIREMENT figures are ONLY under MAXIMUM load. Most machines will never use maximum capacity.

Flow @ 28in wg
fma logo grey

Copyright © 2020 Flowbench Manufacturing Australia. All rights reserved.